This is a high end Custom 21 foot Jet boat with a 310 horse Kodiak Vortec Chevy engine coupled to an American Turbine Super Duty 309 jet with just over a 100 hours on the entire assembly.

Engine

The 301 Horse Kodiak engine is the carbureted version with a closed cooling system also capable of providing heat for the seating area. New ignition components installed in 2025 as well as a fresh oil change. The exhaust system was fitted with internal supertraps to reduce the exhaust volume.

Jet Drive

The American Turbine Super Duty 309 jet was rebuilt with an AA stainless steel impeller in 2012 and has less than 15 hours on it since. There is also a new custom punch grate for the jet intake made of stainless steel to ensure it does not rust out. Receipts available.

Outboard

It also has a 2005 Yamaha 4 stroke outboard, rated at 9.9 horsepower, mounted to the swim grid with a custom aluminum bracket. The Yamaha outboard was purchased new in 2007 and mounted onto the swim grid in 2020. It is a high thrust model with an electric start, extra long leg and power trim. It is connected to the jet with an EZ Steer linkage for steering from the front steering wheel. The shift and throttle controls are also mounted beside the drivers’ seat behind the main engine and jet controls. It can be used for trolling as well as pushing the boat up the Fraser. It has less than 10 hours of use on it. Receipt available.

Hull

The boat has a 4 foot wide strip of ½ inch Teflon attached to the bottom from front to back to make it easy to push off any type of shore and also to protect the bottom of the boat. The centre of the hull is constructed of a 1 foot wide strip of ¾ inch Delta shoe aircraft aluminum on a partial 18 degree V. The rest of the bottom is made from 1/4 inch aluminum with the sides constructed from 1/8 inch ridge stamped aluminum, practically indestructible. The boat has extra high sides to handle rough water and ensure the safety of its’ passengers. There is a very slight indentation on the starboard side near the back of the boat where a jet ski slammed into it. Two gas tanks are in the bottom of the hull holding approximately 200 litres of fuel. The boat is painted except the cuddy, anchor locker and the bottom. The paint shows some galvanic corrosion around the stainless cleats, railing, front gas cap and cover snaps. The sliding door beside the dash enters into a 6 foot unfinished cuddy with a hatch ready for you to complete to your specifications.

Tops and stuff

It also comes with a Sunbrella travel tarp and a ¾ length Sunbrella stand-up top with side and back curtains that can also be converted to just the bimini top. The tops need stiching repairs and some window replacements as can been from the photos.  A two speed fan provides heat into the seating area. Front seats are air cushioned and it has a custom Grant steering wheel. On top of the dash there is a Lowrance lcX-16ci sonar/GPS unit and an iCom ic-m502 VHF Marine radio that is currently not connected.  2 Scotty electric downriggers are also included that have two rod holders on each downrigger.

Trailer

It comes with a galvanized Highliner tandem trailer with hydraulic surge brakes. There is also a hose connection on the trailer with rinse tubes to the brake assemblies in case of any salt water excursions.